3M Black Super Weatherstrip Adhesive: Drying Time, Instructions

3M Black Super Weatherstrip and Gasket Adhesive

7.1

Strenth

10.0/10

Cure time

2.4/10

Versality

9.0/10

Pros

Resists vibration
Waterproof bond
Resistant to oil, extreme temperature changes, and solvents
Convenient application and spreading

Cons

Can make a mess if you are not careful

Buy on Amazon

Physical and Chemical Properties

Physical state: Liquid
Color: Black
Odor: Solvent
Boiling Point: 148 – 189 ºF
Flash Point: -6.00 ºF [Test Method:Tagliabue Closed Cup]
Evaporation rate: >=3.6 [Ref Std:ETHER=1]
Flammable Limits(LEL): 1.00 % volume
Flammable Limits(UEL): 11.50 % volume
Vapor Pressure: 120.0000 mmHg [@ 68 ºF]
Vapor Density: 3.00 [Ref Std:AIR=1]
Density: 0.90 g/ml
Specific Gravity: 0.90 [Ref Std:WATER=1]
Solubility in Water: Slight (less than 10%)
Viscosity: 7,500 – 9,500 centipoise
Hazardous Air Pollutants: 0.57 lb HAPS/lb solids [Test Method:Calculated]
Percent volatile: 60.7 % weight
VOC Less H2O & Exempt Solvents: 560 g/l [Test Method: calculated SCAQMD rule 443.1]

3M Black Super Weatherstrip and Gasket Adhesive

Summary

3M’s Black Super Weatherstrip and Gasket Adhesive will work wonders for bonding rubbers and metals. It is extremely strong, durable, flexible, and convenient at the same time.

This adhesive comes in a small tube that allows for easy and smooth application. You don’t need any additional brushes, and you can spread the glue with just the tip of the tube. This will save you quite a lot of time and effort.

If you need an adhesive that is very durable, this is an excellent choice. It is actually waterproof and not just water-resistant. Also, it is a so-called “weather stripping” adhesive which means that it can withstand almost any weather. Temperature changes, rain, snow, fire, or oil should not interfere with the effectiveness of the adhesive. It can also resist vibration in times of earthquakes or similar occurrences.

One thing you should keep in mind that this might make a bit of a mess. Try to be careful when squeezing the contents out of the tube. If you use too much pressure or do it too rapidly, it might explode and you’ll have glue everywhere. Be gentle so that you may also have pinpoint accuracy in your application.

FAQ

What is the set time?

It will not set right away. You might have to wait a few hours but not overnight.

Can the adhesive be removed?

Yes, it is easily removable with rubbing alcohol and a sharp knife or cutter. You could even simply try to peel it off. The heat will not be necessary to remove the adhesive.